PURPOSE:To eliminate falling and seizure of locating pins and to keep a coaxial degree and a parallel degree of two pairs of bearing holes high accurate equal to the time of simultaneous machining by inserting the locating pins via guide means to locating holes machined together with the bearing holes. CONSTITUTION:Right after bearing holes 1c, 1d, 2c, 2d and locating holes 1a, 1b, 2a, 2b are mach...

PURPOSE:To carry out not only a proportional process but a required integral process by allowing the integral process of errors between a target value and an actual engine speed when an actual speed change ratio in the vicinity of a limit value is moved to an intermediate speed change ratio area side. CONSTITUTION:Errors EOR between a target engine speed NESPR calculated by a throttle opening and ...

PURPOSE:To improve operability by setting a speed change pattern in a manner that a speed change position is moved from a usual position to a low vehicle speed side or a high throttle opening side when it is judged being in slow acceler ation state. CONSTITUTION:Speed change control means C speed-change-controls an automatic transmission on the basis of a speed change pattern set corresponding to ...

PURPOSE:To precisely detect acceleration by changing the judgement threshold value of acceleration signal issuing means for issuing due to the changing condition of the load of an engine, in response to the magnitude of driving load for the engine. CONSTITUTION:Acceleration signal issuing means 30 issue an acceleration signal when the changing condition of the load of an engine detected by changin...

PURPOSE:To prevent erroneous disengagement side control by forcibly prohibiting the release of the engagement side control of lock-up means for a set period from the time of starting of the shift-down of a transmission mechanism after receiving output from down speed change detecting means. CONSTITUTION:Control means 51 detects deceleration operation by detecting means 50 and controls the lock-up ...

A method of untwisting sized yarn in a yarn splicing device, which comprises applying a solution to the ends of sized yarn to dissolve a size to thereby untwist the yarn at the ends thereof when they are joined together by a whirling stream of air.

The cutting device of a covering paper feed in a filter attachment machine for producing filter cigarettes is composed of a blade drum and a cutter drum. The blades are tiltably mounted in axially parallel grooves on the outside of the blade drum and are resiliently loaded at their end faces.

Herein disclosed is a method of controlling an automatic clutch when starting to move a vehicle such as an automobile having an automatic transmission. The maximum accelerating r.p.m. of an engine at the start is detected and stored so that a clutch actuator is kept deenergized to leave the clutch released, while the engine r.p.m. detected is lower than the maximum value stored, but is energized a...

A method of changing bobbins in lot for an automatic winder comprises the steps of hindering fully wound winding units from further winding yarns when an amount of a residual yarn supply becomes smaller than a predetermined value, and discharging bobbins with residual yarn from the fully wound winding units to deliver the same to the other winding units being in winding operation.

A method for recovering sulfuric acid from a titanium sulfate waste liquor by diffusion dialysis in a diffusion dialytic cell provided with anion exchange membranes, which comprises subjecting the titanium sulfate waste liquor to precision filtration to remove a solid content having a particle size of at least 0.1 mu m to a level of not more than 100 mu g/ l , and placing the filtered liquor to ...