The absorber takes the form of at least one plate with channels for a heat carrier and located in an insulated tray-shaped casing closed by a transparent cover plate (12). Between the cover plate and the absorber is at least one convection barrier. The cover plate (12) is divided into sections, the end joint edges of which facing each other are supported by window-type bars (26) supported against ...

PURPOSE:To prevent blowing-up of engine revolutions and shocks likely to occur at the time of clutch engagement by furnishing a pair of clutches with two solenoid valves for generation of alternate signaling oil pressure, and thereby reciprocating a control valve for selective supply of oil pressure. CONSTITUTION:A start controlling solenoid valve 45 and a direct coupling solenoid valve 46 at the ...

PURPOSE:To suppress the impact due to the sharp switching by preventing the switching between advance and retreat when the car speed over a certain value which is set previously is detected by a car speed sensor. CONSTITUTION:When an advance switch 3 is pressing-operated, a speed change transmission mechanism 10 is put to the advance side through a control part 6 and a solenoid valve 11. When a se...

PURPOSE:To prevent the deterioration in the responsiveness for kick-down by carrying out the switching to the direct connection drive only the time when the condition of switching from the continuously variable transmission drive to the direct connection drive is fulfilled and the continuously variable speed change drive time continuous for a certain time or more. CONSTITUTION:A direct connection ...

PURPOSE:To reduce the clutch engagement shock by delaying the speed change of a continuously variable transmission to the low speed ratio by a set time on switching from the direct connection drive to the continuously variable transmission drive. CONSTITUTION:When a controller 170 supplies an ON signal into a start controlling solenoid valve 172 and supplies an OFF signal into a direct connection ...

PURPOSE:To prevent the generation of speed change hunting by suspending the switching from low speed to high speed when the car speed for switching to low speed is realized and by restoring and holding the speed change state to the original low speed. CONSTITUTION:A microcomputer 31 is judging means and holding control means consists of a CPU 32, ROM 33, and a RAM 34. In the RAM 33, a shift-up spe...

PURPOSE:To make the line pressure in case when the oil leak quantity varies always equal to an aimed line pressure by correcting the duty ratio according to the corrected duty ratio quantity determined by the function between the oil temperature and the max. line pressure. CONSTITUTION:In a correction quantity searching means 97, the corrected duty ratio quantity DELTAD is obtained through the map...

PURPOSE:To adequately set the supply air flow rate from a compressor to a boiler by installing a steam turbine to the compressor for pressurizing a pressurized fluidized bed boiler to drive the compressor, and connecting a steam bleeding system and an auxiliary steam system to the steam turbine. CONSTITUTION:The plant is provided with a steam turbine 10 for driving a generator 13 by means of steam...