Method for the operation of a couple (MB3a, MB3b) of memory blocks working in parallel. At least one processor (BP, IOC) reads and writes information into the two blocks (MB3a, MB3b) in a normal operating time with read-write operation, the first block (MB3) respectively storing under one of its addresses the same information as the second block (MB3b) does under the same address. The first and se...

Novel fungicidal active substance combinations of - the known substituted 1-hydroxyethyltriazole derivative of the formula as the first component and - known fungicidal active substances from amongst the groups (A) to (H) mentioned in the description, as the second component.

The device is for applying stamps which are connected in a cohesive strip with intervening perforations. The device comprises a container (10) which is held in the hand, and a mechanism (16) for wetting the surface to be stamped. In the container is a magazine (11) which accommodates a roll of stamps (12). To the magazine is connected a feed-out channel (17) in which the strip of stamps is manuall...

The arrangement is for handling motor vehicles on a roll-on/roll-off ship, and includes a cassette device (14a,14b,14d) moving horizontally on the vehicle decks. The cassette device comprises a cassette (14a) with a storey arrangement connected by ramps and determining the vertical positions in the vehicle deck panels. Further cassettes (14b) constitute a support structure for the vehicle deck pan...

Filter comprises a uniform layer of material which absorbs in the wavelength 280-320 nm. There are also one or two barrier materials. The radiation absorbing material is alpha tocopherol esp. DL alpha tocopherol is blended with a barrier material esp. ground nut oil or ethyl alcohol to give a good consistency and environmental tolerance. - The alpha tocopherol is present as at least 10% and at the...

The tooth protector for sports players comprises a profiled part which fits over the upper jaw to protect against blows. An inner softer plastics layer is formed directly on a mould of the upper jaw of the user. An outer, harder plastics layer is fitted over and joined to the softer layer. A reinforcement layer, which at least covers the two front teeth in the top jaw, is fitted between the inner ...