PURPOSE:To provide an X-ray CT device capable of correct image reading and diagnosis in which continuous projection data can be obtained without forcing a testee to stop breathing for a long time, or in which relative positions of viscera, etc., are not deflected even in the case where the same position is photographed later. CONSTITUTION:A device is provided with a breathing depth measuring means...

PURPOSE:To improve water repellency, resistance to abrasion and the like by a method wherein a first layer is formed by treating a treating agent, containing a compound capable of forming a surface having a specified value of contact angle with respect to water, while a second layer is constituted of a heat resistant polymeric thin film layer obtained by treating with treating agent containing a c...

PURPOSE:To reduce a fuel reset shock in releasing a fuel cut by releasing fuel- cut control after completion of the slip control of a lockup clutch. CONSTITUTION:A duty solenoid valve 39 repeats on-off operations with a duty factor conformed to an input signal and opens or closes a drain line 38 at a very short period, thereby adjusting the extent of pilot pressure in a control line 37 to a value ...

PURPOSE:To make a gearshift lever returnable to a neutral position even at the time of stoppage in a variable speed traveling transmission gear by installing a neutral position switch which turns a steering clutch on or off with an operation at the neutral position of the gearshift lever. CONSTITUTION:A planetary transmission system by way of a planetary gear mechanism and a continuously variable ...

PURPOSE:To actuate a retarder device effectively at the failure time of an automatic transmission so as to reduce the vehicle speed or stop a vehicle rapidly. CONSTITUTION:A vehicle speed sensor 14 and an inhibitor switch 15 for identifying the selected state of a parking position are connected to the speed change control unit 13 of an automatic transmission 3. On the basis of the output, a retard...

PURPOSE:To detect the psychological state of a driver to reflect it on brake control so as to enable brake control corresponding to the driving ability of the driver. CONSTITUTION:A control device for a vehicle is provided with a braking means 20 for making braking pressure act upon a wheel, and an anti-skid brake control mans 130 for controlling braking pressure so that the slip of the wheel beco...

PURPOSE:To prevent generation of steaming in fed water flowing through an economizer in a boiler when a combined cycle power plant falls into a negative load (partial load) operating range. CONSTITUTION:Steam is extracted from an opening of an overheater 18 in a boiler 1, and then the extracted steam is fed to an exhaust recovery heat- exchanger 15 where heat-exchange is carried out between the st...

PURPOSE:To perform automatic assembly through simplification of assembly of a counter shaft by a method wherein when rigidity of a case is increased by integrally forming the auxiliary transmission containing part of a transfer case, the support wall of a counter shaft is detachable from the transfer case. CONSTITUTION:A transfer case 22 to contain an auxiliary transmission 18 and a drive force di...

PURPOSE:To improve an emission characteristic of NOX in a plant when it is started, by stopping the plant increasing the drum pressure of a waste heat boiler to a level higher than that of the pressure when the plant is stopped. CONSTITUTION:A combined plant sets a gas turbine 1, waste heat boiler 20, catalytic denitrifying device 11 and an NH3 injection nozzle 12. The plant, when it is stopped, h...

PURPOSE:To make rigidity in a transmission case ever so high and a delivery oil passage for an oil pump formable in an easy manner, by installing a diaphragm, capable of forming an oil pump setting surface over almost the whole circumference, inside the case. CONSTITUTION:A diaphragm 3, capable of forming an oil pump setting surface 2 over almost nearly the whole circumference, is installed in the...

A method of starting a gas turbine plant, which plant has at least one combustor including a primary combustion chamber into which primary fuel nozzles open and a secondary combustion chamber into which secondary fuel nozzles open, a compressor for supplying the combustor with compressed combustion air, and a gas turbine driven by the combustion gas generated in the combustor and adapted to drive ...

PURPOSE:To improve the traveling performance by using the device in synchronous engagement type and permitting the speed change operation only when the car speed is lower than a standard value and permitting a hydraulic circuit to be unloaded, thus permitting the speed change during traveling. CONSTITUTION:A hydraulic circuit 10 for traveling drive is equipped with a hydraulic pump 11 driven by a ...

A process for adhering a latex film to a polymeric substrate through the formation of covalent bonds at the interface of the polymeric substrate and the latex film. The covalent bonds are formed through the reaction of a cyclic imino ether group, 2-alkenyl-2-oxazoline, and a coreactive group, active hydrogen, epoxy or anhydride group, one of which is present in the polymeric substrate and the othe...